Long-term tribocorrosion resistance and failure tolerance of multilayer carbon-based coatings

Abstract

Current tribocorrosion research of metallic materials and their surface protective coatings mainly focuses on their short-term properties, with test time of 0.5–2.0 h and a sliding distance 50–500 m, which may significantly deviate from the practical long-term service condition and thus cause a catastrophe of marine equipments. In this study, three carbon-based multilayer coatings (Ti/DLC, TiCx/DLC, and Ti—TiCx/DLC) were deposited on S32750 substrates, and both short-term and long-term tribocorrosion behaviors were investigated. The experimental results indicate that the coatings substantially improve the tribocorrosion resistance of the S32750 stainless steel. During the short-term tribocorrosion test, TiCx/DLC exhibited the best tribocorrosion resistance owing to its high hardness. During the long-term tribocorrosion test, however, Ti—TiCx/DLC coating indicated the best anti-tribocorrosion performance owing to its excellent fracture toughness together with high hardness. Moreover, under 5 N, Ti—TiCx/DLC can withstand a long-term test of more than 24 h. Additionally, under a higher load of 20 N, the Ti—TiCx/DLC with a corresponding sliding distance of approximately 1,728 m maintained a low friction coefficient of approximately 0.06. However, the coating was completely worn out; this is attributable to the formation of tribocorrosion products consisting of graphitized carbon and nanocrystalline FexOy.