Long-Term Creep-Rupture Behavior of Alloy Inconel 740/740H

Abstract

To explore potential application of Ni-based alloys for power generation at the higher temperatures and pressures needed to achieve high thermal to electrical-energy conversion efficiency, an extensive creep-rupture dataset covering up to 875 °C and almost 70,000 hours for Inconel 740/740H was analyzed using Larson–Miller parameter and Wilshire approaches. The results were used to assess the relative effectiveness of the two analytical methods, both in describing the experimental data and, because of the breadth of the dataset, using analyses of its shorter-time data to make creep lifetime predictions for much more extended times, which were then directly compared to the measured rupture times. The respective methods were also used to predict creep-limited lifetimes relevant to power production (that is, 100,000 hours or greater). Despite the complexity of the precipitation-strengthened Inconel 740/740H alloy and the generalized parametric approach of these methodologies, the predictions based on such were reasonably accurate when the entire dataset was analyzed. However, when the analysis was confined to only data for conditions yielding creep-rupture times < 5000 hours (about 65 pct of the entire dataset), the Wilshire correlation yielded better prediction for longer time lifetimes due to the inherent instability of the specific Larson–Miller formalism used in this analysis when extrapolated significantly outside its analysis range.