Localization and Imaging of Micro-Cracks Using Nonlinear Lamb Waves with Imperfect Group-Velocity Matching

Yanxun Xiang,Yang Gao,Jichao Xu,Xunlin Qiu,Wujun Zhu

doi:10.3390/app11178069

Yanxun Xiang, Yang Gao + Show 3 more

Open Access

https://doi.org/10.3390/app11178069

Copy DOI

Abstract

Nonlinear Lamb waves have attracted increasing attention for detecting and identifying microstructural changes in structural health monitoring. However, most identification methods that determine the damage locations based on the intersections of the elliptical loci will inevitably cause positioning errors due to the change of the group velocity before and after interaction with the damage. In this work, a method focusing on elliptical rings was proposed for localization and imaging of micro-cracks in a three-dimensional structure using nonlinear Lamb waves with imperfect group-velocity matching. The width of the elliptical rings can be determined by the degree of the group-velocity mismatching of nonlinear S0 modes. The mode pair S0-s0, satisfying approximate group-velocity matching, is mainly introduced by interacting with the micro-crack. The effectiveness of the proposed methodology for damage localization is verified by the experimental testing and numerical simulation. Although the length of the being-tested small crack (about 1 mm) is smaller than the wavelength of the incident fundamental Lamb wave (around 20 mm), it can be well identified and localized using nonlinear Lamb waves. The experimental results show that the proposed method enables more reliable localization of the small crack with the crossover areas, as compared with the intersections based on the ellipse method. Furthermore, a breathing crack not situated in the propagation path can also be well localized by the proposed method in comparison with those by the probability-based diagnostic imaging in the simulation cases.

Highlights

The damage localization of linear cracks and through holes was achieved by the ellipse method, based on the time-of-flight of damage-scattered waves with a spatially distributed array of sensors attached to a homogeneous plate structure [2,3]
It can be clearly seen that the stress induced by Lamb wave propagation is continuously transmitted through the breathing crack when it is closed (Figure 10a), while on the contrary, the transmission process is interrupted when the crack is open (Figure 10b)
A modified ellipse method using nonlinear S0 mode Lamb waves with approximate group-velocity matching is proposed for localization and imaging of micro-cracks

Summary

Introduction

To reduce the risk of catastrophic failure and prolong the lifespan of structures, structural health monitoring (SHM) sensitive to defect-related changes in a real-time manner has been widely applied in aerospace, transportation, civil and mechanical structures, etc. Among various SHM techniques, ultrasonic Lamb wave has been considered as a promising way to detect damages in plate-like structures due to its appealing advantages of high sensitivity to different types of defects and its large inspection range with low attenuation [1]. The damage localization of linear cracks and through holes was achieved by the ellipse method, based on the time-of-flight of damage-scattered waves with a spatially distributed array of sensors attached to a homogeneous plate structure [2,3]. Qualitative or quantitative detection of multiple damage cases [6,7] in engineering structures has become an increasing concern, it seems to be a challenging task

Objectives

Methods

Results

Conclusion