Local mechanical properties of mouse outer hair cells: Atomic force microscopic study

Abstract

Objectives Outer hair cells (OHCs) are capable of altering their cell length in response to changes in membrane potential. Due to this electromotility, OHCs probably subject the basilar membrane to force, resulting in cochlear amplification. To understand the mechanism of such amplification, knowledge of the mechanical properties of OHCs is required since the force produced by OHC electromotility is thought to depend on such properties. Various studies have been conducted to investigate the mechanical properties of guinea pig OHCs. With regard to mice, however, although various kinds of transgenic and knockout mice possess great potential as research models, the mechanical properties of mouse OHCs have not as yet been reported since the cells and/or tissues in the mouse hearing organ are relatively small and vulnerable to external stimuli, rendering sample preparation difficult. In this study, therefore, to establish indicators of the mechanical properties of OHCs in mice, such properties were measured by atomic force microscopy (AFM). Methods CBA/JNCrj strain male mice aged 10–12 weeks (25–30 g) were used. Cochleae were dissected out from the animal and both the basilar membrane and the organ of Corti were simultaneously unwrapped from the modiolus with forceps. Dissected coiled tissue was then incubated with an enzymatic digestion medium for 15 min. After digestion, OHCs were isolated by gently triturating the coiled tissue. Local mechanical properties of the OHCs were then measured by an indentation test using an AFM. Results Young's modulus and stiffness of the OHC in the apical turn of the mouse cochlea were 2.1 ± 0.5 kPa and 4.4 ± 1.2 mN/m, respectively. Conclusions Young's modulus of the OHC in the apical turn of the cochlea in mice was roughly the same as that in the apical turn of the cochlea in guinea pigs; however, the stiffness of the former was about two times greater than that of the latter because the cell length of the former was shorter than that of the latter.