Abstract

A 3D printed solution flow type micro droplet cell (Sf-MDC) was attached to an optical microscope, making it possible to switch between the lens and Sf-MDC at the same observation/measurement area. Using this setup, precipitates in an Al-Si alloy were investigated. Open circuit potential measurements and potentiodynamic measurements were conducted at various surface areas of the Al-Si alloy. The precipitate area ratio affected open circuit potentials and anodic currents. This 3D printed Sf-MDC can be applied for the electrochemical investigation of precipitates in Al-Si alloy.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.