Abstract
Bulk samples (dia. = 20 mm) of various nanocrystalline (nc) Al-Pb alloys with Pb content varying from 1 to 4 at. pct are fabricated using spark plasma sintering of ball-milled powders. Al matrix in Al-2 at. pct Pb alloy had a grain size of 53 nm, and Pb particle size was 6 ± 2 nm. High angle annular dark-field image obtained in STEM mode of TEM indicates the presence of Pb along the nc Al grain boundaries as well as dispersion of smaller Pb particles in the intra-granular regions. Hardness studies are carried out using microindentation and nanoindentation with load varying over three orders of magnitude (100 − 0.1 g). Microindentation yielded slightly smaller hardness values in comparison to nanoindentation possibly because of indentation size effect. Nevertheless both microindentation and nanoindentation resulted in the same trend of hardness for various nc Al-Pb alloys. Hardness of Al-Pb alloys increased with increase in Pb content up to the additions of 2 at. pct Pb, beyond that the hardness is decreased for higher Pb additions of 3 and 4 pct. The initial hardening behavior is explained based on the Orowan particle strengthening. Strain rate sensitivity (SRS) has increased with increase in Pb content reaching a value of 0.1 for Al-4 at. pct Pb alloy. Activation volumes measured are between 2.84 and 6.15 b 3. Higher SRS and lower activation volume suggest that grain boundary-mediated processes are controlling the deformation characteristics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
