Load-displacement properties of the normal and injured lower cervical spine in vitro.

Abstract

The objective of this study was to determine which discoligamentous structures of the lower cervical spine provide significant stability with regard to different loading conditions. Accordingly, the load-displacement properties of the normal and injured lower cervical spine were tested in vitro. Four artificially created stages of increasing discoligamentous instability of the segment C5/6 were compared to the normal C5/6 segment. Six fresh human cadaver spine segments C4-C7 were tested in flexion/extension, axial rotation, and lateral bending using pure moments of +/- 2.5 Nm without axial preload. Five conditions were investigated consecutively: (1) the intact functional spinal unit (FSU) C5/6; (2) the FSU C5/6 with the anterior longitudinal ligament and the intertransverse ligaments sectioned; (3) the FSU C5/6 with an additional 10-mm-deep incision of the anterior half of the anulus fibrosus and the disc; (4) the FSU C5/6 with additionally sectioned ligamenta flava as well as interspinous and supraspinous ligaments; (5) the FSU C5/6 with additional capsulotomy of the facet joints. In flexion/extension, significant differences were observed concerning range of motion (ROM) and neutral zone (NZ) for all four stages of instability compared to the intact FSU. In axial rotation, only the stage 4 instability showed a significantly increased ROM and NZ compared to the intact FSU. For lateral bending, no significant differences were observed. Based on these data, we conclude that flexion/extension is the most sensitive load-direction for the tested discoligamentous instabilities.