Load-dependent run-in and wear behaviour of line-like surface patterns produced by direct laser interference patterning

Abstract

Line-like patterns having periodicities of 6 and 9µm as well a structural depth of 1µm were created by direct laser-interference patterning on stainless steel substrates (AISI-304). Dry sliding tests using a ball-on-disk configuration were performed under dry sliding in order to study the run-in behaviour of these samples as a function of the applied normal load (0.5, 1, 10 and 15mN) and the ball diameter (3 and 6mm). The resulting wear tracks were examined by light microscopy, white light interferometry and scanning electron microscopy in order to study the underlying friction and wear mechanisms. Dependent on the applied normal load, clear differences in the frictional behaviour can be observed. For small normal loads (0.5 and 1mN), the underlying friction and wear mechanism seems to be adhesion-dominated while for 10 and 15mN, plastic deformation and abrasion are the most important contributions. It could be shown that, for small normal loads, the surface pattern with a periodicity of 6µm leads to a significant reduction of the initial and final COF by a factor of roughly 2 and 4, respectively. Regarding the wear performance, no beneficial effects of the laser-patterning could be observed.