Lithic types in ignimbrites as a guide to the evolution of a caldera complex, Taupo volcanic centre, New Zealand

Abstract

Taupo volcanic centre is one of two active rhyolite centres in the Taupo Volcanic Zone (TVZ), and has been sporadically active over the past ca. 300 ka. At least four large-scale ignimbrites have erupted from the centre, including the well documented 26.5 ka Oruanui ignimbrite and 1.8 ka Taupo ignimbrite. Because stratigraphy of earlier ignimbrites and their sources are masked by later volcanism, disrupted by regional tectonics and obscured by poor exposure, indirect methods must be applied in order to determine their source regions. In this paper detailed componentry, density and petrology of lithic fragments from three ignimbrites (Rangatira Point, Oruanui, Taupo) are used to reveal aspects of the sub-Taupo caldera geology, including the evolution of the Taupo volcanic centre, to assist in ignimbrite correlation and to evaluate structures within the Taupo caldera complex. Lithic fragments identify a complex subsurface geology. The Rangatira Point ignimbrite sampled dominantly rhyolite lavas, plus a variety of welded ignimbrites, rare high-silica dacites and a single dolerite. Most lithic fragments in the Oruanui ignimbrite are andesite with minor rhyolite, welded ignimbrite, dacite and rounded greywacke, while in the Taupo ignimbrite, rhyolite is again the dominant lithic component with subordinate welded ignimbrites, andesite, and greywacke. The densities of lithic fragments indicate similar ranges of values for all lava types, and thus density is a poor indicator of lithology. Care must, therefore, be taken before interpreting subcrustal stratigraphy using density as the sole criterion. The petrography and geochemistry of lithic types are more specific, and the variation can be used to identify sources for the ignimbrites. Both pumice chemistry and rhyolite lithic fragments from the Rangatira Point ignimbrite are comparable to domes exposed at the southern end of the Western Dome Complex and, combined with limited outcrop information, suggest the most likely source for this unit is in the northern part of the Taupo caldera complex. The dominance of andesite lithic fragments in the Oruanui ignimbrite suggests a major andesite cone existed beneath the source area, and the different lithic suites between Oruanui and Taupo ignimbrites suggest these ignimbrites came, at least in part, from mutually exclusive collapse structures. We believe that the Oruanui caldera is sited principally in the northwestern part of present-day Lake Taupo and the Taupo caldera in the northeastern part. Identification of abundant ignimbrite lithics in the Taupo ignimbrite, which are considered to represent an intracaldera facies of an earlier ignimbrite, that is not exposed at the surface, suggest there was a further (pre-Oruanui) ignimbrite caldera in the Taupo ignimbrite eruptive vent region.