Abstract
An accurate, reproducible, and sensitive method for the determination of buspirone HCl and its potential impurities is developed and validated. The validated liquid chromaography method is conducted to meet the Food and Drug Administration/ International Conference on Harmonization requirements for the analysis of buspirone HCI in the presence of its impurities. Five buspirone HCI potential impurities, including 1-(2-pyrimidinyl)-piperazine (I), propargyl chloride (II), 3,3'-tetramethylene glutarimide (III), propargyl glutarimide (IV), and the Mannich base-condensate of I-IV fumarate (V), are separated using a microBondapack C18 column by gradient elution with a flow rate 2.0 mL/min. The initial mobile phase composition is 90:10 (v/v) 10mM KH2PO4 (pH 6.1)-acetonitrile. After a 1-min initial hold, a linear gradient is performed in 26 min to 35:65 (v/v) 10mM KH2PO4 (pH 6.1)-acetonitrile. The samples are detected at 210 and 240 nm using a photo-diode array detector. The linear range of detection for buspirone HCI was between 1.25 ng/microL and 500 ng/microL, with a limit of quantification of 1.25 ng/microL. The linearity, range, peak purity, selectivity, system performance parameters, precision, accuracy, and robustness for all of the impurities were also shown to have acceptable values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
