Liquefaction Behavior of a Well-Graded Gravelly Soil under Initial Static Shear Stress in Cyclic Triaxial and Simple Shear Conditions

Abstract

Among other reasons, studies of the liquefaction potential of gravelly soils are limited because of the difficulties involved in preparing uniform specimens, without particle segregation, especially for a well-graded gravelly soil in a dry state for simple shear testing. Errors and difficulties are also involved in compensating for membrane penetration to a gravelly soil specimen in triaxial testing to get reliable data. Thus, innovative approaches for preparing triaxial and simple shear specimens for gravelly soils are introduced and implemented in this study to overcome experimental problems in acquiring accurate test results. In addition to the aim of obtaining reliable testing data on the liquefaction of gravelly soils under initial static shear stress for simulating sloping ground conditions, a study of the effect of various stress paths on the liquefaction resistance of gravelly soils was another goal of this research. In this regard, two sets of cyclic tests using medium-size triaxial and simple shear devices are conducted on a unique soil to compare the liquefaction potential of the tested gravelly soil using these two devices. Results of simple shear tests indicate that as the value of initial static shear stress increases, the cyclic resistance of the tested gravelly soil decreases. However, the results of the triaxial tests show that the variation of cyclic resistance for the tested soil depends on the initial static shear stress level and associated stress reversal conditions. Furthermore, the observed value of the pore water pressure ratio at failure using the strain-based liquefaction criteria for the tested gravelly soil was about 0.85, regardless of the type of testing. In addition, the relationship between the liquefaction resistance of gravelly soils using cyclic triaxial and simple shear devices was obtained.