Linear viscoelasticity, simple and planar melt extension of linear polybutadienes with bimodal molar mass distributions

Abstract

Shear oscillations, simple and planar elongations have been performed with anionically polymerized polybutadienes (PB) and their blends at room temperature. The PB components were of different molar mass averages and of narrow molar mass distributions; the blends had bimodal molar mass distributions and are represented by the weight ratio w of the high molecular component. The crossover G′(ω) = G″(ω) obtained from oscillatory measurements shows correlations with molecular parameters. For the zero shear viscosity the well-known relation η0 ∞ Mw3.4is found. The recoverable equilibrium shear compliance Je0 is nearly the same for the components; for the blends it strongly depends on w with a pronounced maximum at small w. In elongation outside the linear region strain hardening is found; its magnitude depends on Mw of the components, the composition w of the blend, the mode of elongation (simple or planar), and the elongational strain rate. The hardening revealed in the increase of the elongational viscosity above the linear viscoelastic limit increases as a function of w up to a maximum similar to Je0 such that, for both properties, the molecular processes may be the same. The elongational viscosity µ2 (from the lateral stress in planar elongation) is above the linear viscoelastic limit for bimodal and below this limit for conventional broad molar mass distributions. In general, it can be stated that with a more narrow molar mass distribution of linear polymers the elongational behavior of the melts comes closer to the linear viscoelastic limit.