Abstract

BackgroundIf the proportional assist ventilation (PAV) level is known, muscular effort can be estimated from the difference between peak airway pressure and positive end-expiratory pressure (PEEP) (ΔP) during PAV. We conjectured that deducing muscle pressure from ΔP may be an interesting method to set PAV, and tested this hypothesis using the oesophageal pressure time product calculation.MethodsEleven mechanically ventilated patients with oesophageal pressure monitoring under PAV were enrolled. Patients were randomly assigned to seven assist levels (20–80%, PAV20 means 20% PAV gain) for 15 min. Maximal muscular pressure calculated from oesophageal pressure (Pmus, oes) and from ΔP (Pmus, aw) and inspiratory pressure time product derived from oesophageal pressure (PTPoes) and from ΔP (PTPaw) were determined from the last minute of each level. Pmus, oes and PTPoes with consideration of PEEPi were expressed as Pmus, oes, PEEPi and PTPoes, PEEPi, respectively. Pressure time product was expressed as per minute (PTPoes, PTPoes, PEEPi, PTPaw) and per breath (PTPoes, br, PTPoes, PEEPi, br, PTPaw, br).ResultsPAV significantly reduced the breathing effort of patients with increasing PAV gain (PTPoes 214.3 ± 80.0 at PAV20 vs. 83.7 ± 49.3 cmH2O•s/min at PAV80, PTPoes, PEEPi 277.3 ± 96.4 at PAV20 vs. 121.4 ± 71.6 cmH2O•s/min at PAV80, p < 0.0001). Pmus, aw overestimates Pmus, oes for low-gain PAV and underestimates Pmus, oes for moderate-gain to high-gain PAV. An optimal Pmus, aw could be achieved in 91% of cases with PAV60. When the PAV gain was adjusted to Pmus, aw of 5–10 cmH2O, there was a 93% probability of PTPoes <224 cmH2O•s/min and 88% probability of PTPoes, PEEPi < 255 cmH2O•s/min.ConclusionDeducing maximal muscular pressure from ΔP during PAV has limited accuracy. The extrapolated pressure time product from ΔP is usually less than the pressure time product calculated from oesophageal pressure tracing. However, when the PAV gain was adjusted to Pmus, aw of 5–10 cmH2O, there was a 90% probability of PTPoes and PTPoes, PEEPi within acceptable ranges. This information should be considered when applying ΔP to set PAV under various gains.

Highlights

  • If the proportional assist ventilation (PAV) level is known, muscular effort can be estimated from the difference between peak airway pressure and positive end-expiratory pressure (PEEP) (ΔP) during PAV

  • There were no significant changes in PAV-based patient resistance (Rpav), but PAV-based patient elastance (Epav) was significantly higher with a high PAV gain (p < 0.0001)

  • Aw maximal muscular pressure calculated from peak airway pressure and PEEP difference (ΔP) and PAV gain, respiratory muscular pressure (Pmus), oes maximal muscular pressure calculated from maximum difference between passive and active Poes without consideration of positive end-expiratory pressure (PEEPi), Pmus, oes, PEEPi maximal muscular pressure calculated from maximum difference between passive and active Poes with consideration of PEEPi

Read more

Summary

Introduction

If the proportional assist ventilation (PAV) level is known, muscular effort can be estimated from the difference between peak airway pressure and positive end-expiratory pressure (PEEP) (ΔP) during PAV. Mechanical ventilation is a crucial tool in decreasing the respiratory effort required by ventilated patients, diaphragmatic weakness can rapidly develop with complete diaphragmatic inactivity and mechanical ventilation [1]. This type of diaphragmatic powerlessness has been termed ventilator-induced diaphragmatic dysfunction (VIDD) [2]. In a mechanically ventilated patient, the applied pressure is shared between the patient and ventilator [6] This equation is difficult to solve under conventional ventilation because it is challenging to obtain reliable values for respiratory system resistance and elastance. In proportional assist ventilation (PAV), obtaining reliable elastance is possible during spontaneous breathing because the end of inspiration can be determined [7,8,9]

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call