Limitations of the potential step technique to impedance measurements using discrete time Fourier transform.

Abstract

Recently, a new method of measuring impedance of electrochemical systems was proposed in the literature by Yoo and Park (Yoo, J.-S.; Park, S.-M. Anal. Chem. 2000, 72, 2035). It is based on the analysis of system response to a potential step. Differentiation of the applied potential step and the current response in the time domain followed by applying Fourier transform to both signals allows for determination of the system's impedance. It has been proposed that the measurements carried out in a short time period permit the determination of the system's impedance in the whole frequency range. The aim of the present work was to verify the validity of the impedance spectra obtained using this method, as well as to establish the conditions for which the method may be used. This method was tested using simulated data for a simple ideally polarized electrode and a simple one-electron redox system in the solution. The results show that the reliable impedance spectra may be obtained only for frequencies between 1/(NDeltat) and 1/(2Deltat), where Deltat denotes the sampling time and N is the number of points acquired during the experiment. However, the artifacts are generated when the experimental data are extrapolated to lower frequencies.