Lignocellulose sustainable composites from agro-waste Asparagus bean stem fiber for polymer casting applications: Effect of fiber treatment

Abstract

Listen

Translate article

In the past decades, lignocellulose fibers have attracted significant attention due to their low density, environmental friendliness, and biodegradability. Consequently, researchers are intensifying their efforts to explore the potential of lignocellulosic fibers as sustainable alternatives to synthetic fibers in polymer composites. Among various natural fibers identified as potential reinforcements, agro-waste from the Asparagus Bean stem (ABS) which has been discarded as landfill after harvest has emerged as a promising source of lignocellulose fibers for promoting sustainability. This study investigates the reinforcement suitability of ABSF in polymer matrices. A water-retting process was used for extraction, followed by treatment with a 5 % alkali solution. Cellulose content was enhanced to 65 wt%, and fiber density increased to 1.13 g/cm3 after chemical treatment. Thermogravimetric analysis indicated improved thermal stability of the treated fibers up to 247 °C. Morphological analysis showed increased surface roughness and impurity removal. To evaluate the reinforcing effect of the chemical treatment, epoxy composites with 10 wt% reinforcement were developed. The mechanical properties of these composites improved significantly, with more than 1.1 times when used alkali-treated ABSF as reinforcement. Flexural properties were substantially enhanced, with flexural strength increasing from 90.53 MPa to 122.71 MPa and flexural modulus from 2.41 GPa to 2.95 GPa due to better fiber-matrix interaction and removal of weak, amorphous constituents. The primary objective of this study is to demonstrate that ABSF is a viable alternative raw material for composite reinforcement, suitable for developing lightweight structural applications.