Lignin-Containing Coatings for Packaging Materials-Pilot Trials.

Asif Javed,Peter Rättö,Lars Järnström,Henrik Ullsten

doi:10.3390/polym13101595

Asif Javed, Peter Rättö + Show 2 more

Open Access

https://doi.org/10.3390/polym13101595

Copy DOI

Journal: Polymers	Publication Date: May 15, 2021
Citations: 5	License type: CC BY 4.0

Affiliation: Karlstad University, RISE Research Institutes of Sweden

Abstract

One severe weakness of most biopolymers, in terms of their use as packaging materials, is their relatively high solubility in water. The addition of kraft lignin to starch coating formulations has been shown to reduce the water solubility of starch in dry coatings. However, lignin may also migrate into aqueous solutions. For this paper, kraft lignin isolated using the LignoBoost process was used in order to examine the effect of pH level on the solubility of lignin with and without ammonium zirconium carbonate (AZC). Machine-glazed (MG) paper was coated in a pilot coating machine, with the moving substrate at high speed, and laboratory-coated samples were used as a reference when measuring defects (number of pinholes). Kraft lignin became soluble in water at lower pH levels when starch was added to the solution, due to the interactions between starch and lignin. This made it possible to lower the pH of the coating solutions, resulting in increased water stability of the dry samples; that is, the migration of lignin to the model liquids decreased when the pH of the coating solutions was reduced. No significant difference was observed in the water vapor transmission rate (WVTR) between high and low pH for the pilot-coated samples. The addition of AZC to the formulation reduced the migration of lignin from the coatings to the model liquids and led to an increase in the water contact angle, but also increased the number of pinholes in the pilot-coated samples.

Highlights

Lignin, a heterogeneous and thermoplastic biopolymer, is one of the major constituents of wood and is the most hydrophobic component of the plant cell [1]
Lignin is extracted from wood in the pulping process, which separates cellulose fibers
The as-received starch was degraded to a molecular weight (Mw ) of ~1.5 × 106 Da and the degree of hydroxypropylation of the starch was 0.1, according to the supplier

Summary

Introduction

A heterogeneous and thermoplastic biopolymer, is one of the major constituents of wood and is the most hydrophobic component of the plant cell [1]. Lignin is extracted from wood in the pulping process, which separates cellulose fibers. The glass transition temperature (Tg ) of lignin is dependent on the plant species, the extraction process, and the moisture content, and it ranges from 90 to 170 ◦ C [2]. Lignin is extracted from the wood by mechanical, chemical, or enzymatic methods. Soda, sulfite, organosolv, hydrolysis, enzymatic, and LignoBoost processes are examples of lignin-isolation processes typically used to extract lignin from wood [2,3,4,5]. The LignoBoost process has many advantages, compared to other processes; including, e.g., lower investment and operational costs, as well as high lignin yield [5]

Methods

Results

Conclusion