LES and RANS modelling of under-expanded jets with application to gaseous fuel direct injection for advanced propulsion systems

Abstract

A density-based solver with the classical fourth-order accurate Runge-Kutta temporal discretization scheme was developed and applied to study under-expanded jets issued through millimetre-size nozzles for applications in high-pressure direct-injection (DI) gaseous-fuelled propulsion systems. Both large eddy simulation (LES) and Reynolds-averaged Navier-Stokes (RANS) turbulence modelling techniques were used to evaluate the performance of the new code. The computational results were compared both quantitatively and qualitatively against available data from the literature. After initial evaluation of the code, the computational framework was used in conjunction with RANS modelling (k-ω SST) to investigate the effect of nozzle exit geometry on the characteristics of gaseous jets issued from millimetre-size nozzles. Cylindrical nozzles with various length to diameter ratios, namely 5, 10 and 20, in addition to a diverging conical nozzle, were studied. This study is believed to be the first to provide a direct comparison between RANS and LES within the context of nozzle exit profiling for advanced high-pressure injection systems with the formation of under-expanded jets. It was found that reducing the length of the straight section of the nozzle by 50% resulted in a slightly higher level of under-expansion (∼2.6% higher pressure at the nozzle exit) and ∼1% higher mass flow rate. It was also found that a nozzle with 50% shorter length resulted in ∼6% longer jet penetration length. At a constant nozzle pressure ratio (NPR), a lower nozzle length to diameter ratio resulted in a noticeably higher jet penetration. It was found that with a diverging conical nozzle, a fairly higher penetration length could be achieved if an under-expanded jet formed downstream of the nozzle exit compared to a jet issued from a straight nozzle with the same NPR. This was attributed to the radial restriction of the flow and consequently formation of a relatively smaller reflected shock angle. With the conical nozzle used in this study and a 30 bar injection pressure, an under-expanded hydrogen jet exhibited ∼60% higher penetration length compared to an under-expanded nitrogen jet at 100 μs after start of injection. Moreover, the former jet exhibited ∼22% higher penetration compared to a nitrogen jet issued through the conical profile with 150 bar injection pressure.