Abstract

The goal of this study was to characterize the interrelationship between sarcomere length and interfilament spacing in the control of Ca2+ sensitivity in skinned rabbit psoas muscle fibers. Measurements were made at sarcomere lengths 2.0, 2.7 and 3.4 microm. At 2.7 microm the fiber width was reduced by 17% relative to that at 2.0 microm and the pCa50 for force development was increased by approximately 0.3 pCa units. In the presence of 5% Dextran T-500 the fiber width at sarcomere length 2.0 microm was also decreased by 17% and the Ca2+ sensitivity was increased to the same value as at 2.7 microm. In contrast, at sarcomere length 2.7 microm the addition of as much as 10% Dextran T-500 had no effect on Ca2+ sensitivity. At sarcomere length 3.4 microm there was an additional 7% compression and the Ca2+ sensitivity was increased slightly (approximately 0.1 pCa units) relative to that at 2.7 microm. However at 3.4 microm the addition of 5% Dextran T-500 caused the Ca2+ sensitivity to decrease to the level seen at 2.0 microm. Given that the skinning process causes a swelling of the filament lattice it is evident that the relationship between sarcomere length and Ca2+ sensitivity observed in skinned fibers may not always be applicable to intact fibers. These data are consistent with measurements of Ca2+ in intact fibers which indicate that there might be a decline in Ca2+ sensitivity at long sarcomere lengths.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.