Abstract
Large bore natural gas engines have the perennial challenge to achieve ever higher efficiency with ever lower NOx emissions, while maintaining stable combustion, avoiding misfire and engine knock. A primary strategτy to achieve these goals is to run leaner and leaner. However, leaner mixtures lead to reduced combustion stability and the operating space between misfire and engine knock shrinks. Leaner operation requires a high performance ignition system. This report will highlight the fundamental challenges related to lean operation and the progress Woodward has made to create a novel high performance prechamber spark plug to achieve good combustion stability in a passive prechamber spark plug under lean conditions. The spark plug in combination with the appropriate ignition system enables faster and more stable combustion under increasingly lean conditions, improving fuel efficiency and emissions. Engine simulation modeling is used to demonstrate the benefits of lean gas mixtures and reduced combustion duration to enhance the NOx versus fuel consumption trade-off for a range of air fuel ratios. With this database available, a design requirements flow-down is performed such that combustion performance requirements can be specified a priori, which if met would ensure the high level engine emissions and performance targets would be met. With combustion requirements in hand, CFD simulations are used to identify the mechanisms by which flame propagation is improved with prechamber spark plugs in general, and by the Lean Quality Plug (WW-LQP) prechamber spark plug under development at Woodward. Experimental validation was carried out to confirm the benefits of lean operation and improvement of combustion stability (COV) on the NOx-efficiency trade-off. Operation with Woodward’s WW-LQP spark plug and IC1100 AC ignition system showed improved fuel efficiency at constant NOx on a high BMEP engine. Additionally, the enhanced stability and low COV of the WW-LQP enables extension of the natural gas lean limit closer to λ = 2.00 for an open chamber engine.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have