Abstract
Solvent extraction is used to reduce lead concentrations from millpond wastewater solids, a type of foundry process waste. Toluene and toluene mixed with di-(2-ethyl-hexyl) phosphoric acid (HDEHP) have been tried as leaching solvents. Toluene is ineffective as a solvent in extracting lead, but the toluene-HDEHP mixture effectively removes lead from solid foundry waste. The effects of the HDEHP concentration, the contact time, and the amount of solvent used on lead extraction have been investigated. The mass transfer process is rapid: contact time of 1/2 hour has been found to be sufficient to accomplish the leaching process. The concentration of HDEHP significantly impacts lead removal. The optimum concentration of HDEHP is determined to range from 0.05 to 0.1 mol/l. The Toxicity Characteristic Leaching Procedure (TCLP) test of the treated samples gives leachable lead in much lower quantities than those found in the untreated samples. Thus the solvent extraction process appears to be an effective method to significantly reduce the lead content of millpond wastewater solids.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Air & Waste Management Association
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
