Lead in Meat and Meat Products Consumed by the Population in Slovakia

Golian Jozef,Lukáčová Anetta

doi:10.3844/ajavsp.2014.263.268

Abstract

The presence of heavy metals in food is the consequence of atmosphere contamination of polluted soil, waters and results in contaminated feed with heavy metals. The lead concentrations depend on the environmental conditions and the food production methods. The monitoring of lead concentration in meat is important for human health. The aim of this study was to determine the level of lead in the traditional and popular meat products consumed in Slovak republic. This study was carried out to determine the levels of lead in Lovecka salami and selected Ham products during the technological processing. The raw materials originating from domestic and foreign production were compared. Lead concentrations were measured by the method of AA spectrometry with the graphite furnace (Perkin Elmer A Analyst 800; MA, USA). Mean concentration of lead in the starting materials in Lovecka salami for the pork of foreign production had the highest mean lead level (0.607 ppm), followed by beef from foreign production (0.518 ppm), pork from domestic production (0.377 ppm), pork bacon from foreign production (0.173 ppm), beef from domestic production (0.142 ppm) and pork bacon from domestic production (0.106 ppm). The highest concentrations of lead were found in the homogenized samples with addition of additives and spices (salt, sodium ascorbate, erythorbic acid, ground black pepper, sugar, garlic, starter culture) from foreign starting materials and final samples from foreign and domestic production in Lovecka salami (0.769; 0.811 and 0.676 ppm, respectively). The highest concentrations of lead in the selected Ham product were found in final sample from foreign production (0.813 ppm), followed by final sample from domestic production (0.740 ppm), homogenized sample with additives (salt, Sodium Nitrite, Sodium Pyrophosphate, Sodium Tripolyphosphate and Ascorbic acid) from foreign starting material and domestic starting material (0.791 and 0.697 ppm, respectively). The lowest mean Pb concentration in selected Ham was found in the starting materials (pork thigh) from domestic and foreign production (0.344 and 0.397 ppm, respectively). In the present study, samples of lead were higher than the maximum lead levels allowed by Commission Regulations (EC) No1881/2006. The allowable level for lead is 0.1 mg kg-1. Technological process of meat processing can create a potential source of heavy metals risk in final products. Improvements in the food production and processing technology are increasing the chances of food contamination with various environmental pollutants, especially heavy metals.

Highlights

Metals are found in all living organisms where they play a variety of roles
This study reported high concentration of lead than those described in our study
The levels of lead in meat and meat products consumed by the population in Slovakia were determined

Summary

Introduction

Metals are found in all living organisms where they play a variety of roles. Non-essential elements such as Pb, Cd, Cr, Ni and As are considered to be toxic and their presence in the body can cause profound biochemical and neurological changes in the body (Chowdhury et al, 2011). The sources of toxic metals in the environment are the fossil fuels, mining industries, waste disposals and municipal sewage. Farming and forestry contribute to the metal content in the environment due to the uses of fertilizer, pesticide and herbicides (Jayasekara et al, 1992). These metals stay permanently because they cannot be degraded in the environment (Baykov et al, 1996). They enter into the food material and from there they make their passage into the tissue (Munoz-Olives and Camara, 2001)

Objectives

Results

Conclusion