Abstract
Pastes prepared with seven lead-free glass particles were screen-printed and fired on 96%-Al2O3 substrates. The fired films were studied in terms of sintering, devitrification, crack propagation and bleeding. The most promising glass compositions were selected for the preparation of RuO2-based thick film resistors (TFRs), on pre-fired PtAu- or PdAg-based terminations; electrical properties of the resistors (sheet resistance vs. RuO2 volume fraction, temperature coefficient of resistance and size effects) were investigated. The study evidenced a myriad of complex phenomena, including devitrification, relevant bleeding of the glass on alumina substrates, anomalous distribution of conductive grains in the glassy matrix, phase separations. Contrarily to what happens in traditional systems, it is difficult to get a wide resistance range simply by changing the fraction of the conductive phase. These results emphasize the criticality in the choice of the glass composition for the preparation of lead-free thick film resistors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Materials Science: Materials in Electronics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
