Abstract
Ethanol sensing in dry and humid air by layered surface acoustic wave (SAW) devices is presented. The transducing platform is based on 36° YX LiTaO3 layered SAW device, utilising a 1.2μm zinc oxide (ZnO) intermediate layer and 150nm tungsten trioxide (WO3) sensing layer. Sheet conductivity calculations show that maximum sensitivity is achieved for ZnO layer thickness between 1 and 1.5μm. Sensor performance was analyzed in terms of response magnitude as a function of operational temperature and different relative humidity (RH). Frequency shifts of 119, 90 and 86kHz towards 500ppm of ethanol in synthetic air were observed for 0, 25 and 50% RH, respectively. All RH levels were measured at 20°C. At an operating temperature of 300°C, the largest response towards 500ppm of ethanol was observed. Response magnitude was found to decrease with increasing RH and decreasing operating temperature. Furthermore, the effect of elevated temperatures on the sensors surface morphology is characterised by AFM and SEM techniques. It is suggested that the morphological modifications, due to elevated temperatures play an important role in the sensing behaviour of the WO3 films.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
