Abstract
In this work, multi-principal element alloys (MPEAs) with the five base elements Al, Cr, Fe, Ni and Ti plus elements in minor amounts were produced by powder metallurgy and their microstructure and elastic behavior were analyzed via light and scanning electron microscopy, electron backscatter diffraction (EBSD) and synchrotron X-ray diffraction. The two studied compositions are an MPEA with Al, Cr, Fe, Ni and Ti in equimolar ratio as well as a similar composition with a concentration of Ti reduced to 10 mol%. The goal is to analyze the microstructural behavior of these compositions during macroscopic loading in dependence of chemical composition and phases present. Analysis via synchrotron X-ray diffraction predicts the presence of body-centered cubic phases, Full Heusler-phases and C14_Laves-phases in both compositions, MPEA5 and MPEA_Ti10. Synchrotron X-ray diffraction offers the possibility to monitor the deformation of these phases during macroscopic loading of specimens. Thermodynamic calculations of stable phases predicted a microstructure of MPEA5 consisting of body-centered cubic and Full Heusler-phases at room temperature. Further calculation and X-ray diffraction experiments showed the stabilization of minor amounts of C14_Laves-phase (hbox {Fe}_2hbox {Ti}) at room temperature with a decreasing amount of Ti. MPEA5 showed the development of long and un-branched cracks during compressive testing, which resulted in a remarkable decrease in lattice-dependent elastic moduli. MPEA_Ti10 exhibited branched cracks during compression tests. Also, the lattice-dependent elastic moduli of MPEA_Ti10 did not change notably during the compression tests. In both compositions, the Full Heusler-phase showed the lowest lattice-dependent elastic moduli, hence taking the largest share of the overall deformation among all phases present in the materials under macroscopic loading.
Highlights
High-entropy alloys (HEAs) and related concepts have proved their potential to provide exceptional material properties in countless research projects within the last decade [1,2,3]
The stress–strain curve of MPEA5 obtained in the dilatometer shows three positions where an increase in strain occurs
The dependence of macroscopic stress applied via compression tests on the evolution of lattice strain was detected via synchrotron X-ray diffraction at Beamline III of DESY [14]
Summary
High-entropy alloys (HEAs) and related concepts have proved their potential to provide exceptional material properties in countless research projects within the last decade [1,2,3]. By stepwise approaching the chemical composition of L718, it was intended to study if positive material properties of MPEA5 and L718 can be successfully combined. Due to their very attractive material properties, the alloys are potentially suitable for load-bearing applications in the high-temperature regime fulfilling further requirements regarding wear and oxidation resistance [11,12,13]. To understand the macroscopic mechanical properties of MPEA5 and MPEA_Ti10, the reaction to mechanical loading of individual phases was analyzed for different reflecting planes For this matter, cylindrical samples of the materials were tested and changes in their microstructure and phase-specific mechanical response during compression tests were analyzed via synchrotron X-ray diffraction.”
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
