Abstract
Both Global Positioning System (GPS) measurements and studies of Late Quaternary faulting are consistent with a slip rate of ∼10 mm/yr along the central segment of the Altyn Tagh Fault and a systematic decrease in that rate toward the eastern end of the fault. Dates of terraces above and below laterally offset terrace risers yield bounds on Quaternary slip rates that range from those that agree with GPS measurements to values as much as three times faster. We argue that offset terrace risers that are protected by topography upstream of them are more closely dated by the age of the upper terrace than by that of the lower terrace. In some cases, valleys upstream of the fault have been incised into bedrock, and few if any terrace risers can be seen within the valleys. Such streams debouch onto alluviated floodplains or fans that become incised, presumably during climate changes, to create terrace risers. The terrace risers are then displaced so that they lie downslope from bedrock ridges on the upstream side of the fault, and thus the risers become protected from further incision. In such cases, dates of upper terraces should more closely approximate the ages of the risers than those of lower terraces. Such dates yield slip rates of ∼10 mm/yr in the central segment of the fault and decreasing rates eastward. Although we cannot with certainty rule out the higher slip rates along the Altyn Tagh Fault, our analysis does show that viable interpretations consistent with GPS measurements are more likely, at least along some segments of the fault. Not only do these rates support the view that the Tibetan Plateau deforms internally by slip on a distributed network of faults in the shallow brittle crust, and hence behaves as a continuum at depth, but the gradual decrease toward the east also shows that the Altyn Tagh Fault does not separate two effectively rigid lithospheric plates. Correspondingly, the relatively low slip rate and the eastward decrease in slip rate suggest that the Altyn Tagh Fault does not transfer a significant portion of the convergence between India and Asia into northeastward extrusion of the Tibetan Plateau. Thus, large‐scale extrusion of crustal material in India's path into Eurasia seems to be limited largely to the confines of the Tibetan Plateau.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.