Abstract
In paper, weld joints between VT1-0 titanium and AISI 321 austenitic stainless steel using laser welding were obtained. To improve the quality and strength properties of joints, two types (SS–Cu–Nb/Ta–Ti) of explosively welded four-layered composite inserts were used. Barrier layers were different from each other by refractory metal. The effect of intermediate material inserts, in particular tantalum and niobium, on microstructure, chemical composition, strength properties, and fracture behaviour of weld joints was studied. Microstructural studies have revealed two bonding types as results of welding method combination. At copper–stainless steel interface, severely deformed zone characterized by low etch ability was observed. Technological parameter’s optimization provided high joint quality and absence of defects in the weld joints. According to results of strength tests, it was found that the composite insert material affects the strength of the joints. The highest ultimate tensile strength and yield strength were detected for joints containing niobium foil.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
