Abstract
We have investigated neodymium: yttrium aluminum garnet (Nd:YAG) laser triggering of a 500-kV, SF6-insulated gas switch for a range of laser parameters. Laser wavelengths of 266 nm and 1064 nm with nominal pulse lengths of 2- and 4-nsec full width at half maximum (FWHM) were used to trigger the switch. The switch was triggered by focusing the laser to form a breakdown arc in the gas between the electrodes. Subnanosecond jitter in the operation of the switch was obtained for 266-nm laser pulse energies as low as 5 mJ. Results obtained with the Nd:YAG laser are compared to earlier data in which the switch was triggered with a krypton-fluoride laser operating at 248 nm with a pulse length of 20-nsec FWHM. Our experimental results show that ultraviolet laser triggering gives results which are a dramatic improvement over infrared laser triggering in terms of lower jitter and smaller change in delay time with variations in applied voltage. We also see indications that the optimum laser pulse length is equal to or greater than the closure time of the switch.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
