Laser Safety Evaluation of the Oscmar M203PI Grenade Launcher Simulator (GLS) and the Associated Umpire Control Gun

Abstract

A laser safety evaluation and pertinent output measurements were performed (during March and April 2002) on the M203PI Grenade Launcher Simulator (GLS) and its associated Umpire Control Gun manufactured by Oscmar International Limited, Auckland, New Zealand. The results were the Oscmar Umpire Gun is laser hazard Class 1 and can be used without restrictions. The radiant energy output of the Oscmar M203PI GLS, under ''Small Source'' criteria at 10 centimeters, is laser hazard Class 3b and not usable, under SNL policy, in force-on-force exercises. However, due to a relatively large exit diameter and an intentionally large beam divergence, to simulate a large area blast, the output beam geometry met the criteria for ''Extended Source'' viewing [ANSI Std. 2136.1-2000 (S.l)]. Under this ''Extended Source'' criteria the output of the M203PI GLS unit was, in fact, laser hazard Class 1 (eye safe), for 3 of the 4 possible modes of laser operation. The 4'h mode, ''Auto Fire'', which simulates a continuous grenade firing every second and is not used at SNL, was laser hazard Class 3a (under the ''Extended Source'' viewing criteria). The M203PI GLS does present a laser hazard Class 3a to aided viewing with binoculars inside 3 meters from the unit. Farther than 3 meters it is ''eye safe''. The M203PI GLS can be considered a Class 1 laser hazard and can be used under SNL policy with the following restrictions: (1) The M203PI GLS unit shall only be programmed for: the ''Single Fire'' (which, includes ''Rapid Fire'') and the ''Auto Align'' (used in adjusting the alignment of the grenade launcher simulator system to the target) modes of operation. (2) The M203PI GLS shall never be directed against personnel, using binoculars, inside of 3 meters. DOE Order 5480.16A, Firearms Safety, (Chapter 1)(5)(a)(8)(d) and DOE-STD-1091-96, Firearms Safety (Chapter 4); already prevents ESS laser engagement of personnel (with or without binoculars), ''closer than 10 feet (3.05 meters)''. Both of these restrictions can be administratively imposed, through a formal Operating Procedure or Technical Work Document and by full compliance with DOE orders and standards.