Abstract
The study addresses the issue of the absence of high-quality WC-Co composite powder for laser powder bed fusion and assessing the printability of the new powder in terms of densification, microstructure and mechanical properties. The fluidized bed chemical vapor deposition (FBCVD) combined with electroless plating process was adopted to make core-shell structured WC-Co composite powder. The excellent uniformity of Co and good powder flowability were achieved by tuning the size and distribution of Co catalyst during FBCVD and regulating their relationship to the subsequent electroless plating behavior. The newly developed composite powder exhibited excellent printability. The densification mechanism was largely dependent on the laser energy density. The liquid formed by the melting of Co was responsible for the densification at low laser energy density, while the Co-W-C ternary liquid resulted from the dissolution of WC into Co melt dominated the densification at high laser energy density. Microstructurally, the morphology and size of WC grains were insignificantly changed because of its non-participation with liquid formation at low laser energy density. The rectangular/triangular WC grain morphology similar to the traditional sintered was formed at high laser energy density because of the precipitation of WC from the Co-W-C ternary liquid. Affected by the different liquid formation processes, increasing laser energy density increased the relative density, promoted the W 2 C phase formation and decreased WC grain size, which remarkably improved the hardness and tribological properties of the printed cemented carbide.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.