Abstract
Lasers have been widely used in surface modification. In the present research, a CO2 continuous wave laser has been used to polish slot surfaces of silica rods. Strong absorption of 10.6 μm CO2 radiation by the silica surface promotes softening of a very thin layer of material that flows under the action of surface tension forces. A smooth surface forms, which decreases the surface roughness without substantial change in surface geometry. The effect of laser-surface inclination angle on the requisite power requirement has been assessed experimentally and theoretically. Using a computer controlled laser beam scanning system, reliability and reproducibility have been greatly improved compared with an alternative surface finishing method, manual fire polishing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
