Abstract
Parametric study of laser microdrilling of Ytrria stabilized Zirconia coated titanium plates employing 12kW CO2 laser was conducted in order to investigate the influence of laser power, frequency and assist gas pressure on quality characteristics such as spatter deposition area, entrance circularity, entrance and exit diameter and taper. Spatter deposition area was found significantly influenced by laser power. Entrance circularity and entrance diameter was influenced by assist gas pressure. Exit diameter was influenced by both laser power and assist gas pressure. Taper angle was influenced by assist gas pressure. Multi objective optimization using Grey Relational Analysis indicated that minimum spatter deposition (19.1152mm2), nominal entrance circularity (0.8709), entrance hole diameter (1mm) and exit hole diameter (0.5709) and minimum taper angle (2.1421°) corresponded to 2000W laser power, 10kHz frequency and 5bar assist gas pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
