Laser-generated Macroscopic and Microscopic Surface Structures for the Joining of Aluminum and Thermoplastics using Friction Press Joining

Abstract

Structural lightweight construction is increasingly utilized in the aerospace and automotive industry. Hybrid structures have great potential, especially with regard to load-specific component layouts. Usually, a surface pre-treatment is applied prior to joining dissimilar materials to improve bonding mechanisms such as form closure. In previous studies pulsed wave (pw) lasers were used for structuring metals. This paper presents the results of aluminum pre-treatment via a continuous wave (cw) single-mode fiber laser: macroscopic and microscopic structures were generated on the aluminum surface; the samples were joined with glass fiber reinforced polyamide using Friction Press Joining (FPJ), a method for joining metals and thermoplastic polymers in lap joint configuration. Using these new methods for surface structuring, shear strength was increased by 40% compared to previous studies with pw lasers.