Abstract
Abstract Cutting of thick austenitic stainless steel sheets with a disc laser is not fully developed. In this research were investigated the surface of holes made on 3.25 mm thick stainless-steel cut with CO2 laser beam and disk laser beam. Using optical microscope and electron microscope to examine the cutting surfaces, were observed that the cutting with the CO2 laser result high quality surface (cutting 3,25 mm thick plates), but holes made with solid-state laser has microcracks on the inner side. These cracks are not acceptable to the customers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
