Laser additive manufacturing of bulk and powder ceramic materials: mathematical modeling with experimental correlations

Abstract

PurposeThis paper aims to develop efficient and simple models for thermal distribution, melt pool dimensions and controlled phase change in the laser additive manufacturing (AM) of bulk and powder particles ceramic materials.Design/methodology/approachThis paper proposes new analytical models for the AM of bulk and powder bed ceramic materials. A volumetric moving heat source, along with the complete melting of bulk and powder particle materials, is taken into account. Different values of laser absorption coefficient in solid and liquid states have been used to investigate the phase transformation. Furthermore, the pores and voids dimensions are also included in the modeling. Theoretical predictions have been compared with the experimental analyses and finite element simulations in laser to silicon nitride and laser to alumina interaction. The analysis focuses on the impact of laser power and scanning speed on the melt pool width and depth evolution into the bulk substrate and powder bed.FindingsThis study shows that the powder particles exhibit a higher thermal distribution value than the bulk substrate because of voids in the powder layer. The laser beam experiences multiple reflections in the presence of porosity/voids, thus increasing the surface absorption coefficient, which becomes relevant with the increment in the pore/void dimension. A direct relationship has been found between the laser power and melt pool dimensions, while the scanning speed displayed an inverse relationship for the melt pool width and length. Larger melt dimensions were inferred in the case of laser–powder particle interaction compared with laser–bulk substrate interaction. A close correlation was found between the analytical simulations, experimental investigations and numerical simulation results within the range of 4%–8%.Originality/valueThis paper fulfills an identified need to develop efficient and simplified models for ceramics laser AM by taking into account different laser absorption coefficients in solid and liquid form, voids and pores dimensions and controlled phase transformation to avoid vapors and plasma formation. The limitation of the finite element simulation model is that the solution is strongly dependent on the mesh quality and accuracy directly linked to the computation efficiency and time. A finer mesh requires a longer computing time than a coarse mesh. Finite element simulations require, however, specialized skills.