Abstract

SiC thin films (undoped and doped with SnO 2 at 1 at.%, 5 at.% and 10 at.% concentrations) are prepared using pulsed laser deposition on quartz substrates kept at room temperature. The XRD patterns show a crystalline cubic phase for the undoped and 10 at.% SnO 2 doped SiC thin films while 1 at.% and 5 at.% SnO 2 doped SiC thin films exhibit an amorphous nature. The formation of nanorods with a non-uniform distribution of nanoparticles are studied using various microscopic techniques such as scanning electron microscopy (SEM), transmission electron microscopy (TEM) and atomic force microscopy (AFM). Non-uniform distribution of particles with an average diameter 50 nm is seen in SEM micrographs of undoped SiC. On doping with 10 at.% SnO 2 , nanorods of average length of 1 micron are formed which is evidenced from the SEM image. TEM images also supports the formation of nanorods of average diameter of 20 nm in the 10 at.% SnO 2 doped SiC thin films. TEM images also suggest the formation of nano particles of size ∼ 5 nm in 10 at.% SnO 2 doped SiC thin films. A low surface roughness of 3.6 and 1.69 nm is obtained for the undoped SiC and 10 at.% SnO 2 doped SiC thin films from the AFM analysis. The presence of Raman bands in the region 500– 600 cm−1 for all the samples indicates the disorder prevailing in the films. It is seen that with higher dopant concentrations, this band becomes more well-defined and appear with more intensities at higher wave numbers which suggests that SnO 2 doping increases disorder in the crystallites in the films. Optical band gaps of the films are estimated from the UV-Vis absorption spectra. Variation in band gap observed with doping concentration may be due to broadening of the absorption edge occurred by the impurity levels. A near interface trap induced blue photoluminescence is observed in the undoped, 5 at.% and 10 at.% SnO 2 doped SiC thin films. The open aperture Z-scan measurements revealed strong absorptive nonlinearities. The Z scan curves suggest that the films are good saturable absorbers with saturation intensity I s being 6 × 1012 and 5.9 × 1012 W/m2, respectively for the 1 at.% and 10 at.% SnO 2 doped SiC films.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.