Large Tank Evaluation of a GPS Wave Buoy for Wind Stress Measurements

Abstract

AbstractThere exists considerable disagreement among the observed values of the drag coefficient CD. To develop a model of CD, the wind stress generally will be calculated from the eddy correlation method. A buoy is suitable to measure the wind stress in many sea surface conditions. However, the motion correction is very difficult because the anemometer measures the wind components, including the motion of the buoy. In this study, as a first approach, the motion of a prototype buoy system with a three-axis sonic anemometer and a six-axis motion sensor installed in the small-size GPS observation buoy was investigated. The wave tank is in the ocean engineering basin of the Institute of Industrial Science, University of Tokyo, Japan. The imposed conditions were wave periods from 1.1 to 2.5 s; wind speeds of 0, 2, and 5 m s−1; and the wave spectrum was either regular or irregular. The motion of the buoy was measured in 120 cases. For all the wave periods and without wind, the wind velocity measured by the sonic anemometer and the velocity of the anemometer motion calculated from the motion sensor data showed good agreement. Also, in the condition with wind speeds of 2 and 5 m s−1, the motion-corrected wind velocity, obtained by deducting the velocity of the anemometer motion from the wind velocity measured by the anemometer, yielded the true wind velocity with better-than-average (4.3%) accuracy. The friction velocity from corrected wind velocity components shows agreement with the friction velocity measured from a fixed sonic anemometer within expected intrinsic error. The buoy system is expected to be able to measure the wind stress in the field. The next stage is to do comprehensive field tests.