Abstract
Laminar flames of three C 3H 6O isomers (propylene oxide, propionaldehyde and acetone), representative of cyclic ether, aldehyde and ketone species important as intermediates in oxygenated fuel combustion, have been studied experimentally and computationally. Most of these flames exhibited a non-linear dependency of flame speed upon stretch rate and two complementary independent techniques were adopted to provide the most reliable burning velocity data. Significant differences in burning velocity were noted for the three isomers: propylene oxide + air mixtures burned fastest, then propionaldehyde + air, with acetone + air flames being the slowest; the latter also required stronger ignition sources. Numerical modelling of these flames was based on the Konnov mechanism, enhanced with reactions specific to these oxygenated fuels. The chemical kinetics mechanism predicted flame velocities in qualitative rather than quantitative agreement with the measurements. Sensitivity analysis suggested that the calculated flame speeds had only a weak dependency upon parent fuel-specific reactions rates; however, consideration of possible break-up routes of the primary fuels has allowed identification of intermediate compounds, the chemistry of which requires a better definition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.