Abstract
Plated-through hole (PTH) is essential part which it connects one layer to other layers in multilayer printed circuit board (PCB). PTH is commonly made by electroplating process with copper as based conductive material. This research objective to simulate the electroplating process in which mass of copper generated using LabVIEW which it is used together with Faraday’s law of electrolysis. The simulation using LabVIEW software and experiment are applied in this study. The simulation and the calculation results of copper mass on the PCB and PTH surfaces were displayed in LabVIEW interface. On the other hand, the experiment is also conducted to form PTH and determine the mass of copper experimentally on the PCB and PTH surfaces. The experiment results showed that PTH was successfully formed in multilayer PCB with electroplating process. The results of copper mass adhered in multilayer PCB in which they were obtained from LabVIEW simulation or calculation are not much different with the copper masses obtained experimentally. The copper masses obtained from experiment tend smaller than the calculation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
