Laboratory Tests of Large-Scale Block Models on the Load Transfer and Failure Mechanisms of Rock Masses Subjected to Anchor Loading

Abstract

AbstractThis paper presents a laboratory testing rig designed to investigate the failure mechanisms and load transfer of rock masses under rock anchor loading. The study revealed that joint patterns significantly affect the strength and capacity of the rock mass, with existing design approaches based on apex angles of 90$$^{\circ }$$ ∘ or 60$$^{\circ }$$ ∘ found to be potentially overly conservative. Joint orientation and spacing should be included in the anchor design to obtain a more precise design criterion. In all the studied patterns, increasing the horizontal and vertical stress increased the block models’ capacity, and load arching did not occur in the model with an unfavourable joint orientation. This study also revealed that the failure surface followed the joints in all tests and that the block model capacity was significantly higher than estimated with the design principle based on the weight of the overlying rock. The findings of this work have important implications for designing rock anchoring systems in mining and civil engineering demonstrate that joint orientation and block size significantly affect the rock mass capacity. This study confirms the need to consider the influence of in situ stresses on rock mass capacity when designing of rock anchors. Overall, this work guides the development of more precise design criteria for rock anchors, contributing to more efficient and effective rock engineering practices.