Abstract
A sensitive; simple and label-free method for DNA detection is presented. Irradiated polyethylene terephthalate foils were etched to present conical tracks at a density of approximately 5×107 tracks per cm2. Probe DNA was immobilized at the narrow opening of the tracks (2–4nm diameter). The presence of target DNA resulted in changes in both conductance and rectification ratios in a concentration-dependent manner. DNA concentrations as low as 2nM could be detected using this simple two-step detection scheme.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
