Abstract
AbstractSince the first contributions by Gedye and Giguere in 1986, growing attention has been registered on the use of microwave heating in organic synthesis. However still many aspects need to be clarified especially about the so called “microwave effect” and the possible degradation phenomena that may be recognized during polymer synthesis. In this work the complex cone-25,27- dipropyloxy-26,28-dioxo-calix[4]arene titanium (IV) dichloride (1) has been tested for the ring opening polymerization of L-lactide, comparing the effect of conventional heating with a possible microwave assisted strategy. The polymers obtained were fully characterized (NMR, IR, HPLC-SEC, DSC, MALDI-TOF and WAXD analysis). As expected the use of microwave irradiation induced an increase of the polymerization rate. On the other side the use of microwaves resulted in a slight loss of the control over molecular weight and molecular weight distribution if compared with a conventional thermal treatment.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
