Abstract
This work describes a microwave technique used to generate and process data on knots in wood prior to processing. The experimental design was a simple system composed of a microwave emitter and receiver used to scan the wood samples with knots. Signals were calibrated and amplified, and then a data storage and graphic visualization were performed. A PCL-711 data acquisition card was used in conjunction with data acquisition software. The preliminary results obtained for the studied wood samples were viewed in 2- and 3-dimensional graphics, showing a strong relation with the visual inspection of the samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
