Knee joint biomechanics of patients with unilateral total knee arthroplasty during stationary cycling

Abstract

Stationary cycling is typically recommended following total knee arthroplasty (TKA) operations. However, knee joint biomechanics during cycling remains mostly unknown for TKA patients. Biomechanical differences between the replaced and non-replaced limb may inform applications of cycling in TKA rehabilitation. The purpose of this study was to examine the knee joint biomechanics of TKA patients during stationary cycling. Fifteen TKA participants cycled at 80 revolutions per minute and workrates of 80 W and 100 W while kinematics (240 Hz) and pedal reaction forces using a pair of instrumented pedals (1200 Hz) were collected. A 2x2 (limb × workrate) repeated measures ANOVA was run with an alpha of 0.05. Peak knee extension moment (KEM, p = 0.034) and vertical pedal reaction force (p = 0.038) were significantly reduced in the replaced limbs compared to non-replaced limbs by 21.3% and 5.3%, respectively. Peak KEM did not change for TKA patients with the increased workrate (p = 0.750). However, both peak hip extension moment (p = 0.009) and ankle plantarflexion moment (p = 0.017) increased due to increased workrate. Patients following TKA showed similar decreases in peak KEM and vertical pedal reaction force in their replaced compared to non-replaced limbs, as previously seen in gait. Patients of TKA may rely on their hip and ankle extensors to increases in workrate. Increasing intensity by 20 W did not exacerbate any inter-limb differences for peak KEM and vertical PRF.