Kinetics of an anaerobic fluidized bed reactor using biolite carrier

Abstract

Start-up and steady state operation of anaerobic fluidized bed reactors (AFBRs) with biolite as the inert carrier material was studied. Start-up and concomitant biofilm development of AFBRs was performed using two common start-up techniques, the maximum efficiency profile (MEP) technique and the maximum load profile (MLP) technique. The MEP start-up technique increases the volumetric organic loading rates to the reactor gradually and is tied to the removal efficiency of the process. The MLP start-up technique maintains a moderately high but constant volumetric organic loading rate irrespective of reactor performance. Using sucrose-based wastewater as feed, both start-up techniques led to equally fast biofilm development and start-up times of approximately 5 weeks. However, the MEP technique resulted in more stable controlled reactor operation during the start-up period. The quick start-up confirms the high compatibility of biolite for bio-adhesion and the development of a healthy active biofilm.High concentrations of biofilm biomass achieved in AFBRs (69 g volatile biofilm solids (VBS)/L of expanded bed volume at an organic loading rate of 25 g COD/(Lùd)) allowed the successful treatment of wastewaters at high organic loading rates and organic removal efficiencies. During steady state experiments, organic removal efficiencies over 80% were obtained for organic loading rates as high as 20 g COD/(L∙d). It was found that the dependence of removal efficiency on hydraulic retention time is influenced by substrate concentration. Total biofilm yield was determined to be 0.08 g VBS/g COD removed, demonstrating the low net synthesis of solids in the AFBR. AFBRs had an average solids retention time of 150 days, corresponding to a washout factor of 0.01. Extrinsic kinetics of the AFBRs was determined to be zero order with a maximum specific utilization rate of 0.48 g COD/(g VBS∙d).AFBRs used to treat municipal landfill leachate with a BOD5:COD ratio of 0.86 achieved steady state COD removal efficiencies that ranged from 70% to 87%, depending on the reactor organic loading rate and the concentration of the leachate being treated. During leachate treatment, biofilm biomass gradually became "mineralized" as a result of precipitation of metal sulfides and carbonates. This eventually resulted in a decrease in biofilm microbial activity and the need for higher pumping rates to maintain the same degree of bed expansion. Key words: anaerobic, biological fluidized bed reactor, biolite, landfill leachate, sucrose, modeling, start-up, steady state kinetics.