Abstract
Polystyrene microcellular foams blowing with supercritical CO2 were prepared with a novel polymer foam processing simulator. Key parameters influencing Polystyrene cell morphology were investigated. The effect of processing temperature and saturation pressure on cell morphology was observed by scanning electron microscope and the average cell diameter and cell size distribution was calculated. The results show that the cell density decrease and cell size increase with the increase of foaming temperature. The cell density increase and cell size decrease with the increase of saturation pressure. And the cell size distribution shows a narrow distribution at lower foaming temperature and higher saturation pressure.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
