Abstract
The commercial 7xxx series Al alloys are based on medium strength Al-Zn-Mg and high strength Al-Zn-Mg-Cu systems. The medium strength alloys are weldable, whilst the high strength alloys are nonweldable. On the other hand, the Cu-free, weldable alloys suffer from poor SCC resistance. It is the purpose of this article to provide quantitative data and microstructural analysis to demonstrate that small additions of either Ag or Sc to Al-Zn-Mg and Al-Zn-Mg-Cu alloys bring about very significant improvement in SCC resistance and weldability, respectively. The improvement in SCC resistance of the Cu-bearing alloys due to over aging and retrogression and reaging (RRA) is further discussed in light of a similar improvement in the SCC resistance of these alloys, when peak aged, due to Ag and Sc additions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
