Joint Contact Changes With Undersized Prosthetic Radial Heads.

Abstract

To evaluate the effect of intentional undersizing of prosthetic radial head implant diameters on joint contact pressures. Eight fresh-frozen cadaveric elbows were aligned in neutral extension and loaded with 100 N using a custom testing apparatus. Radiocapitellar contact pressures were recorded using a Tekscan thin-film pressure sensor. Prosthetic radial head replacement was performed with 2 prostheses: the Anatomic Radial Head and the Evolve Proline Radial Head prostheses. Each design was sized according to the manufacturer's recommendations and then again using 2-mm smaller radial heads. Average and peak pressures were significantly higher with the Evolve than the Anatomic prostheses (P < 0.03 and 0.02, respectively). Peak pressures decreased from 4.2 ± 0.5 MPa to 2.9 ± 0.3 MPa for the Anatomic Radial Heads and from 5.6 ± 0.5 MPa to 3.9 ± 0.6 MPa when the Evolve Radial Heads were undersized by 2 mm. The mean pressures of the Anatomic Radial Heads (1.4 ± 0.1 MPa) did not change significantly with undersizing (1.3 ± 0.1 MPa, P = 0.12), whereas the mean pressures of the Evolve Radial Heads (1.6 ± 0.1 MPa) were significantly reduced with undersizing (1.4 ± 0.1 MPa, P < 0.02). Both mean and peak pressures were initially high for the Evolve Radial Head sized based on the short axis diameter and were improved with further undersizing by 2 mm. Peak, but not mean, contact pressures were improved by undersizing the Anatomic prosthesis based on the long axis diameter. These findings support the clinical recommendation of some surgeons to undersize the Evolve prosthesis by 2-mm smaller diameter than the current manufacturer's suggestion and give reason to consider doing the same for the Anatomic prosthesis.