Joining of Zirconia Reinforced Metal-Matrix Composites

Abstract

Metal-matrix composite materials, based on a metastable austenitic stainless steel reinforced with a magnesia partially stabilised zirconia have been prepared by a ceramics-derived extrusion technology. Using this powder metallurgical method enables the shaping of lightweight cellular structures as well as bulk specimens with a variety of steel/ceramic ratios at room temperature. However, the extrusion of composite structures is limited by the uniform cross section throughout its entire length. Joining of these metal-matrix composite preforms after sintering by conventional welding techniques is a challenging task. The presence of ceramic fractions may lead to several complications and the subsequent heat exposure during joining may initiate phase transformations in both metastable components resulting in a deterioration of the mechanical properties of the composite material. An adapted ceramics-derived joining technology allows the combination of varying TRIP-steel/zirconia composite materials. The main features are the machining and joining of the parts in their dry green state at room temperature before their thermal treatment. Thus, the material’s consolidation and the formation of the joint take place simultaneously. The ability of joining different parts offers the possibility to create structures for complex applications and testing conditions. The key to advanced properties of the joining zone are the base materials, the surface treatment of the parts, and the paste used for joining. The joining process of different base materials, the mechanical properties, and the microstructure of sinter-joint samples are presented.