Abstract
The ultraviolet spectroscopy of the S(1) <-- S(0) transition of 1-phenylcyclopentene (PCP) was studied by resonant-two-photon ionization (R2PI), laser-induced fluorescence (LIF) and single vibronic level fluorescence (SVLF). UV-UV hole-burning (UVHB) spectroscopy was used to determine that there is only one spectroscopically distinct conformer in the supersonic expansion. The excitation spectrum shows extensive vibronic structure extending to over 1000 cm(-1) above the electronic origin (34,646 cm(-1)). Much of the vibronic structure is similar to that of styrene and other singly substituted benzene derivatives, with Franck-Condon (FC) activity predominantly in substituent-sensitive benzene modes. Sizeable FC progressions were also found in the inter-ring torsion, reflecting a large displacement in the inter-ring angle upon electronic excitation. No evidence for FC activity in the ring-puckering coordinate is observed. The torsional potentials of the ground and excited states were determined from the experimental transition frequencies by fitting the calculated to the experimental torsional frequency spacings in an automated least-squares fitting procedure. The S(1) torsional potential is a symmetric single-well potential centered around a locally planar equilibrium geometry at a torsional angle of varphi = 0 degrees . The energy levels are reproduced by a cosine term potential function with torsional parameters V(2) = 3765 cm(-1) and V(4) = -183 cm(-1). The S(0) torsional potential possesses a twisted equilibrium geometry that is strongly asymmetric about varphi = 0 degrees due to the non-planarity of the cyclopentene ring. The best-fit potential parameters uses a sin/cos potential function (odd/even), with V = 948 cm(-1), V = -195 cm(-1), V = -162 cm(-1) and V = -268 cm(-1). The shape of the potentials are similar to those predicted by relaxed potential energy scans calculated at the DFT, CIS and TDDFT//CIS levels of theory. The change in the torsional angle varphi upon electronic excitation was determined to be approximately 15 degrees from fits of the displacement delta of the S(0) torsional potential with respect to the S(1) potential. The simulated shift of the S(0) potential with respect to the S(1) potential of approximately 15 degrees is in very good agreement with that obtained from B3LYP calculations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.