Abstract
The creep and creep recovery behavior under the stress-controlled subloop loading in TiNi SMA tape were investigated. The results obtained can be summarized as follows. (1) If stress is kept constant at the upper stress plateau after loading up to the stress-holding start strain under a constant stress rate, creep deformation occurs due to the spread of the SIMT process. (2) If stress is kept constant at the lower stress plateau after unloading down to the stress-holding start strain from the maximum strain under a constant stress rate, creep recovery deformation occurs due to the reverse transformation. (3) If the stress-holding start strain is large, the creep strain rate under constant stress is high and the maximum strain is large. The creep strain rate increases based on temperature increase due to the exothermic SIMT up to the stress-holding start strain.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The Proceedings of Mechanical Engineering Congress, Japan
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.